BilbyCNC - Extruder Vitamins

You are here: Vitamins > Extruder Hardware Kit

Extruder Hardware Kit

26nd March, 2012

This kit is compiled by BilbyCNC from local and imported ingredients.
It contains the parts to build a standard Wades or Gregs Extruder. We can tweak the parts in the kits on request, such as slightly longer or shorter bolts. Contact Us with your requirements.

Bolts	4 x M3 x 10mm cap screws (Allan bolts) - for mounting your stepper motor 4 x M3 x 45mm cap screws - for applying pressure to the filament 2 x M4 x 20mm hex head bolts - for mounting the extruder to the Y-carriage 1 x M3 x 5mm set screw - for fixing your drive gear to your stepper shaft 1 x M8 hobbed bolt
Washers	4 x M3 washer 4 x M4 washers 4 x M8 washers
Nuts	5 x M3 nuts 2 x M4 nuts 1 x M8 nylon nut
Other	4 x Pen Springs - for applying pressure to the filament 3 x 608z Deep Groove Ball Bearings 20mm x 8mm dia. smooth stainless steel rod

Buy now:

Full extruder instructions here

What's not included

Plastic Parts
- Extruder Body
- Small drive gear
- Large driven gear
Nema17 stepper motor (here)
- PTFE tube (3mm or 1.75mm Inner Diameter)
- Brass Barrel (3mm or 1.75mm Inner Diameter)
- Hot End Kit
  - Aluminium Block
  - Heat Resistor
  - Thermistor
- Brass Nozzle (0.34 or 0.5mm hole)
Cables (here
Kapton Tape, 6mm or above (here

Your Cart Is Empty

Keep Up To Date
Join Our Email List

Categories:

3D Printing

CNC Parts

Tools

3D Routers

Software

Gift Certificates

Other Pages: